Metal Shredder Manufacturers Teach Users What To Pay Attention To Before Starting The Machine

Matters that should be noted during the installation of metal shredder equipment. The first thing to pay attention to is the line problem. Once the line is good, it is the problem of fixing the metal shredder equipment. If it is fixed firmly enough, it can not only make the vibration of the metal shredder smaller, but also be more suitable for long-term production. After fixing, start testing the metal shredder equipment, turn on the shredder, and then idle. After idling for a few minutes without any problems, it means that our shredder has been installed and production work can be carried out smoothly. When the metal shredder is fixed, the metal shredder should be fixed on the cement foundation. If you want to change the work location, the shredder and the motor should be installed on the base made of angle iron. If your metal shredder is powered by a diesel engine, you must first consider the power matching problem. The power of the diesel engine should be slightly greater than the power of the shredder, so that the performance of the metal shredder can be fully utilized. After the metal shredder is fixed and installed, before starting the machine, you must first check whether the connecting bolts of each part of the metal shredder are tightened, whether the tightness of the transmission belt is appropriate, whether the power cord is connected, whether the motor shaft and the rotating shaft of the metal shredder are consistent and parallel. After checking the above matters, the host should also check whether the hammer of the metal shredder is well installed, whether the aperture of the screen is appropriate, whether there is damage or blockage, etc., and it is best to drag the belt by hand to check whether the main shaft is flexible and whether there is any jamming and friction. In addition, after starting the machine, it is best to let the machine idle for a while to check whether the operation of each part of the metal shredder is normal. At this step, the installation and test run of the metal shredder is basically completed. If there are no problems, the metal shredder can be officially put into production.
The scope of use of metal shredders is becoming more and more extensive, and the technology of designing and producing metal shredders is constantly improving, so that metal shredders can better complete the crushing of more materials. So how to solve the problem of too large materials in the crushing of metal crushers, and improve the qualified rate of crushed materials.
This type of problem is solved from the feed port. For special materials, we will communicate with customers in advance to change the feed port size for crushing. For example, the crushing effect of car shells, refrigerators, waste home appliances, and waste children's toys is very ideal. Driven by the motor, the rotor of the large-caliber metal shredder rotates at high speed. When the material enters the hammer crushing area, it collides with the steel hammer on the rotor and is crushed. Then it is thrown onto the extrusion device and crushed again. The willfulness is reduced through secondary extrusion, and it returns to the metal shredder cavity for crushing. This work is repeated. We only need to set the material size control size of the output material. When the qualified material meets the specified particle size requirements, it can flow out along the double screen. The unqualified material will continue to work in the machine cavity until it is qualified. Users can go to Kesheng Machinery to inspect and test the machine. The metal crusher models and specifications are very complete.